|
Post by magicmodel on Aug 14, 2013 14:43:54 GMT -5
Hi Sumpod fans, I have a really easy one for you......... At the moment I have the following setup on my Sanguinololu 1.3a board for my Sumpod Delta: and when I connect in Pronterface I get the following encouraging looking message: BUT......when I try to move steppers nothing happens. Am I missing something really obvious? Thanks Magicmodel3DPrinting Never Sleeps
|
|
|
Post by bdureau on Dec 28, 2013 3:57:59 GMT -5
Hello I have a very similar board that came with my SUMPOD basic. I can move the steppers however the Y stepper is going reverse. Do I need to modify the code and upload it or are they any other way to change the stepper direction?
|
|
|
Post by bdureau on Dec 28, 2013 4:29:54 GMT -5
I am using the reptier host software Attachments:
|
|
|
Post by peteus on Dec 28, 2013 21:42:23 GMT -5
I have yet to try mine seeing as I have been way to busy with my other projects but, I think you have your driver chips in the wrong way around. The site does show a diagram and then says they are the other way around underneath it. Hope it helps. Current bit's i'm stuck on with my build are how the hot end goes together and where do the limit switches sit? Also do you know how to mount the hot end to the head?
|
|
|
Post by bdureau on Dec 29, 2013 5:20:36 GMT -5
hello I have fixed the firmware, no change to the hardware. Find attached my config file. I have now the axes in the correct direction but I am not sure about the other parameters in the firmware. For the hot end it it quite easy I will post some pictures of mine Boris Attachments:
|
|
|
Post by bdureau on Dec 29, 2013 5:41:31 GMT -5
here is a picture of my printer hot end Attachments:
|
|
|
Post by peteus on Jan 13, 2014 19:08:04 GMT -5
Hey, I'm having the issues of the steppers not working. So, I think I need to upload new firmware but, I'm unsure as to how upload it. I have downloaded the arduino IDE but, I am unsure as to how to connect it to the sanguinolou to it.
|
|
|
Post by bdureau on Jan 14, 2014 1:51:51 GMT -5
If you want to change the firmware you need Arduino 0023 + the Sanguino files. You then need to copy the Sanguino directory under the hardware directory
Like this "your harduino dir"\hardware\Sanguino
Where did you download the firmware?
|
|
yohai
New Member
Posts: 1
|
Post by yohai on Jan 28, 2014 5:46:33 GMT -5
the configuration.h isn't the same for delta printers you must have delta settings enabled inside it
|
|