|
Post by bdureau on Jan 24, 2014 18:22:50 GMT -5
How do you cleanup your hot end nozzle Mine keeps on being blocked
|
|
|
Post by ratmonkey on Jan 26, 2014 12:04:08 GMT -5
loose the filament in the extruder, so that you could pull it out. then begin to heat up your hot-end and start to pull the filament out. pull gently and keep pulling while the hot-end is heating up.
since its hot enough (for pla 60-80°C) you should be able to pull the filament out. pull it slowly out. if all works correktly you should have a clean hotend and the dirt at the end of your filament.
if you have the all-metal hotend, then you could try to dry your filament (just park it on a radiatorfor some hours). pla starts to suck up water from the air and starts to make problems if it is to wet. some types of pla are almost unprintable in all-metal hotends.
|
|
|
Post by bdureau on Jan 27, 2014 15:31:48 GMT -5
I think that I have the all metal hot end..... Which one would you recommend? Attachments:
|
|
|
Post by ratmonkey on Jan 28, 2014 2:07:21 GMT -5
Yep. you have the all metal. Dont know wich one is better. Ich have the old one with ptfe-liner and peek-barrier.
|
|