Marlin Error: 'Y_MIN_POS_DEFAULT' was not declared in this s

[rena]

hi guys, 

replacing the configuration.h und configuration_adv.h with the delta settings from the examples folder and setting the motherboard to 81 ,Printrboard (AT90USB1286).
when compiling this leads to the following error:

ConfigurationStore.cpp:338: error: 'Y_MIN_POS_DEFAULT' was not declared in this scope

ConfigurationStore.cpp:339: error: 'Z_MIN_POS_DEFAULT' was not declared in this scope

ConfigurationStore.cpp:340: error: 'X_MAX_POS_DEFAULT' was not declared in this scope

ConfigurationStore.cpp:341: error: 'Y_MAX_POS_DEFAULT' was not declared in this scope

ConfigurationStore.cpp:342: error: 'Z_MAX_POS_DEFAULT' was not declared in this scope


can someone help?

[jason]

My guess is somewhere in configuration. H
You need to declare those constants...
Try asking the arduino editor to find any of those strings..'Y_MIN' ETC.
It is likely they are present and waiting but "commented out"

Something like // #define Y_MIN_POS_DEFAULT 123

And the other axis the same
You needto make 123 the right value for you machine and remove the // which tells the compiler to 'ignor' the define of your needes constant

[burningbecks]

It might be less trouble to just get the "clean" version to compile an then fill in the specific paramters (controller board, mechanical dimensions, ...) in "Configuration.h".
At least this was the way I did it => burningbecks.wordpress.com/2015/11/07/building-a-sumpod-aluminium-v2-kit/
( Airtripper's general guide => airtripper.com/1145/marlin-firmware-v1-basic-configuration-set-up-guide/ )