|
Post by tombate on Sept 29, 2013 16:19:37 GMT -5
Hi, I recently finished building my sumpod basic, and after some time fiddling with pronterface I had everything homing perfectly and moving in both directions. However I wanted to finetune some settings in marlin (z axis length was too short) I downloaded the sumpod sanguinello file from the sumpod website, and uploaded it to my board. When I connected the board to pronterface, it responded to every command (X,Y or Z) by moving the Z axis very slowly downwards. I pressed the Z endstop and the axis continued to move downwards. When I used M119 I checked all of the endstops, and they all worked (changed to H when pressed). Really confused as to what I've done, and unsure where to start. Thanks very much!
|
|
|
Post by tomguest on Nov 14, 2013 22:00:37 GMT -5
make sure that the z endstop is connected correctly as mine goes up when triggered and then down again
|
|