jason
Full Member
Posts: 114
|
Post by jason on Dec 6, 2014 14:48:30 GMT -5
Good stuff... Out of curiosity which chip? Intriguing that stepper worked with heater off but didn't with heater.
|
|
|
Post by bdureau on Dec 6, 2014 14:51:39 GMT -5
head is now vomiting melted PLA Will have to try some print
|
|
|
Post by bdureau on Dec 6, 2014 18:06:58 GMT -5
Good stuff... Out of curiosity which chip? Intriguing that stepper worked with heater off but didn't with heater. This was the atmega1284 I did remove it the other day to flash the bootloader
|
|
jason
Full Member
Posts: 114
|
Post by jason on Dec 6, 2014 18:55:18 GMT -5
Oh.
|
|
|
Post by bdureau on Dec 8, 2014 15:57:20 GMT -5
|
|
|
Post by bdureau on Dec 8, 2014 16:00:40 GMT -5
I would like to thanks all those in this forum who helped me to understand how a 3D printer works
|
|
jason
Full Member
Posts: 114
|
Post by jason on Dec 8, 2014 16:59:11 GMT -5
Pleasure to discuss something other than Richard. ..
|
|
|
Post by bdureau on Dec 13, 2014 4:39:07 GMT -5
ok I have been trying some print out, all the firmware setting are just working great, I can print the first layer but then the head just jam. I can now help people with their firmware configuration. So I am going to ask questions rgarding the hotend problems in the appropriate post.
|
|