|
Post by ninthlife on Mar 28, 2016 23:24:09 GMT -5
I'm having trouble getting my prints to turn out right, i think its just nozzle/bed temp settings and my bed isnt perfectly level.
Does anyone have a printing profile for Cura or some gcode that works on their Sumpod Aluminium (big, not mega)?
|
|
|
Post by ninthlife on Aug 25, 2013 5:12:13 GMT -5
What firmware do you use?
|
|
|
Post by ninthlife on Aug 25, 2013 5:07:55 GMT -5
|
|
|
Post by ninthlife on Jun 22, 2013 0:15:04 GMT -5
There should be separate build instructions for each iteration of SUMPODS, as there are some variations, especially when it comes to firmware settings, steps per mm, etc...
|
|
|
Post by ninthlife on Mar 17, 2013 1:15:41 GMT -5
Update, sorry for the double post, but I found this New question; could I run the contrast (CONTR), to a digital pin an set it via software? And, Do I need to tie R/W to ground, or is leaving it floating OK? and, I don't want the back light on all the time, do you think i could run that to a pin, and add a timeout to the firmware? probably getting in over my head here, but hey.
|
|
|
Post by ninthlife on Mar 16, 2013 22:05:01 GMT -5
Hi everyone, I got a kit from Richard, instead of the assembled unit, and the only thing i am struggling with is the LCD. I've found a few guides (including this terrible one www.sumpod.com/pages/electronics) and there are differences in all of them. could someone post a photo of their connections and/or a diagram? Does the rotary encoder connect to the 16 pin header with the LCD, or to it's own AUX in? Thanks guys
|
|