|
Post by bdureau on Jan 29, 2015 7:27:32 GMT -5
I haven't got any so I will give teflon tape a try and will post the results on the forum I am using PLA so max temp will be 200°C which shouch be ok because teflon is melting around 260°C
|
|
|
Post by bdureau on Jan 29, 2015 7:24:02 GMT -5
For the extruder speed I would ajust it with the frontend software For exemple Repetier host allow you to do that in the manual control tab. Then you need to look at your print and make sure that the layers stick well, you can tell when there is not enought, sometime you even see missing layers
|
|
|
Post by bdureau on Jan 29, 2015 7:20:22 GMT -5
This is where to change it in your firmware #define DEFAULT_AXIS_STEPS_PER_UNIT {2*42.50,2*42.50,1066.67,105} The way I did it was by priting a cube 10x10x10 mm and then measured it and I adjusted the step/mm Then do a 100x100x2 cube, measure it and re-adjust the step/mm
|
|
|
Post by bdureau on Jan 29, 2015 2:36:34 GMT -5
can you tell me what is not calibrated so that I can point you to the settings that need to be changed
|
|
|
Post by bdureau on Jan 29, 2015 2:12:05 GMT -5
I think that you need to adjust the printing temperature
|
|
|
Post by bdureau on Jan 29, 2015 2:09:53 GMT -5
I have removed my nozzles to try different size but the little o-ring that was between the nozzle and hotend as disapeared. It is now leaking a bit of plastic so what can I use to replace it?
|
|
|
Post by bdureau on Jan 27, 2015 6:43:08 GMT -5
|
|
|
Post by bdureau on Jan 26, 2015 6:53:39 GMT -5
Could you post your firmaware configuration.h file so that I can help you configure it. If you do a little schema of your wiring and show us the axes directions and end stop that would help.
|
|
|
Post by bdureau on Jan 26, 2015 6:49:42 GMT -5
Hi all I am looking for an easy to use CAD software that my kids could use to create their own designs. They are 10 and 12 years old, quite good with computers but I cannot let them use stuff like Openscad Any ideas?
|
|
|
Post by bdureau on Jan 25, 2015 7:16:36 GMT -5
This is what I did to leave my printer printing nearly unatended Attachments:
|
|
|
Post by bdureau on Jan 25, 2015 6:08:09 GMT -5
A key chain camera holder for my rockets
|
|
|
Post by bdureau on Jan 25, 2015 6:07:02 GMT -5
Some more nozzle for my shuttle Attachments:
|
|
|
Post by bdureau on Jan 23, 2015 14:35:44 GMT -5
I have his email somewhere but I will send it private
|
|
|
Post by bdureau on Jan 22, 2015 23:59:00 GMT -5
|
|
|
Post by bdureau on Jan 20, 2015 16:19:19 GMT -5
|
|